Subaru Outback Forums banner

impreza outback sport

  1. CV joint is not sitting flush with seal after wheel bearing change

    Wheels, Tires, Brakes, & Suspension
    Hi everyone, I just replaced both my rear wheel bearings with NTN bearings. I was tightening my axle nut and realized that it was not tightening as far back as it should with the CV joint. As you can see in the photos, the axle joint is not sitting flush with the outer bearing seal. I didn't do...
  2. 2006 Subaru Impreza Outback: Need help removing bearing from rear driver side

    Wheels, Tires, Brakes, & Suspension
    Hello everyone, I am in the middle of replacing my wheel bearing on my 06 Impreza and I have run into a problem removing the bearing from the rear driver side. I rented the Oriley's master hub remover to do the job. I already finished the rear right side, but when I pushed out the bearing, the...
  3. 2011 Subaru Outback Sport - Error code P0304 following head gasket replacement and loose vacuum hose

    Problems & Maintenance
    I have a 2011 Subaru Outback Sport that I had head gaskets/timing belt/water pump replaced on 2 months ago. Since then, it ran and idled rough, but not horribly. My friend/mechanic looked it over and found a vacuum hose completely unconnected (not sure where the hose was connected, but it was...
  4. FS - Southern CA, 07’ Impreza Outback Sport

    For Sale / For Free
    Up for sale is my 2007 outback sport, I've owned it since 2016, it has a salvaged title but the accident that caused that had been 10+ years ago. Car has been functioning just fine. after i bought it (150k miles) i have done a lot of the suggested maintenance needed for high mileage car. Now it...
Top