Subaru Outback Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. Gen 3: 2005-2009
    Good afternoon, Went to do my plugs and wires today on my 2008 2.5i 60k miles outback. The sparkplug boot had tons of oil on cylinder 4. Im still there in fact as I write this. I finally got the plug out and there is lots of oil on the threads. The sparker was fine. But due for a change...
  2. Problems & DIY Maintenance
    Did my plugs the other day - 2016 2.5L Outback Premium. I have oil in the spark plug tube and on wires which I will address with valve cover and tube seal replacement. The question I have is about this hole that I discovered at the bottom of the tube. See photo. Is this a drain hole? If so...
  3. Gen 3: 2005-2009
    I read in a post where they say you can lift the engine up a couple inches by undoing the engine mounts and jacking up from the underside. I've been trying to do that to access the last bolt holding the valve cover on (driver's side). In the image it's the bolt (that you can't see) at the lower...
  4. Spark Plug Seal 10966 AA000 Nippon Reinz W0133-1642466

    Side by side comparison on a 2000 Outback Wagon driver side valve cover.
  5. Spark Plug Seal 10966 AA000 Nippon Reinz W0133-1642466

    New Spark Plug Seal smaller than space provided for it in the valve cover.
  6. Spark Plug Seal 10966 AA000 Nippon Reinz W0133-1642466

    New Part Dated 12/3/9 on left smaller diameter than OEM part on right.
  7. Spark Plug Seal 10966 AA000 Nippon Reinz W0133-1642466

    New part on top has a completely different profile than Original Part.
1-8 of 8 Results
Top