Subaru Outback Forums banner

1 - 1 of 1 Posts

·
Registered
2008 Tribeca Limited
Joined
·
31 Posts
Discussion Starter #1
Was chasing a “clunk” sound from the rear end and it appears all of the blushing on the rear knuckle are past their useful life.. the car just recently turned 200k miles so I’m not too surprised. The control arms are a little sloppy too but the brushing in the knuckle are real bad...
I’ve recently done all 4 corners for struts/shocks, front control arm assemblies, sway bar bushings (fronts were shot but rears were in pretty good shape).

Question(s):
Has anyone done a rear knuckle busing replacement?
Are these bushings pressed in (metal sleeved) or just rubber inserts into the knuckle?
Has anyone seen a DIY post for this? I searched but I don’t see anything for the Tribeca.

Thanks for any help.
 
1 - 1 of 1 Posts
Top