manual 99 obw 185k. i bought this car a year and a half ago and it has always had a problem with whining. When i reach 55mph there is a slight whine then it disappears until i hit about 65mph. When i put it into cruise control it is gone but when I accelerate it comes back and then stops when i let off the gas. Please help!
99 obw whine when accelerating
Join the discussion
Recommended Reading
-
09 Outback | Need to replace the engine wiring harness
Problems & MaintenanceThe dealer will do it for ~$950 parts and labor. I'm trying to figure out if I can do the change out without having to purchase anything other than the harness [Harness Engine - Subaru (24020AE050) -= ~$300]. If the process is fairly straight forward, I can probably handle the install -...- 13
- 174
-
TJW04 · updated
-
Rod Knock? '09 2.5l Non-turbo
Problems & MaintenanceI was riding on the highway on cruise when the car downshifted to go over a rise, and suddenly started knocking loudly. I limped <1 mile to a gas station, it never threw a code but the oil light was flickering on right as I parked it. It wasn't dripping oil, but there was some on parts...- 0
- 17
-
Failed differential
Problems & MaintenanceSo I bought my first Subaru. A 2020 Outback XT Outdoors (Onyx) in the States. At about 500 km I started hearing a whine, at first I thought that it was the transmission. I took the car back to the dealership and it turned out to be be the rear differential. On the upside, the dealer was awesome...- 3
- 136
-
Altaboy · updated
-
Err SS on a 2009 Outback
Problems & MaintenanceI purchased my Subaru from a used car dealership. I keep on getting an Err SS on my dashboard along with Check Engine Light, ABS Light on, No traction and Cruise Control Light Flashes. Went on You Tube found it might be my Gas Cap. I replaced the Gas Cap. Check Engine & Cruise Control Light went...- 2
- 92
-
Mating engine to manual transmission
Problems & MaintenanceHello everyone,, Have done this a number of times with non-Subbys. Used alignment tool, everything in line, can draw it in with bolts to 1/2 inch and can no longer turn engine over. Back bolts off and it releases. Tranny input shaft definitely in clutch plate. What is going wrong?????- 3
- 57
Join now to ask and comment!