Subaru Outback Forums banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Ride of the Month Challenge!

1 - 1 of 1 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Okay, yesterday I changed my rear struts on my 1998 Outback. Unfortunately I didn't see the strut was caught on the ABS line on the drivers side as I was putting it in and I pushed the strut against the line pretty hard. Apparently I broke or disconnected something cause now the ABS light is on and of course it no longer functions.

Visually I can't see a problem and the connection doesn't appear loose. I did run a scan with an ODBC scanner and it didn't throw a code.

Any suggestions, common experiences, or ideas before I proceed?

Thanks.
 
1 - 1 of 1 Posts
Top