Subaru Outback Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Recently purchased a 2017 Outback 3.6R and noticed that the windshield wasn't OEM. The plastic cowl at the bottom of the windshield has a small gap between the top of the cowl and the windshield.

I'd like to purchase a rubber seal to close the gap but I'm having difficulty locating the exact part needed. A few calls to Subaru parts dealers lead me to part # 91441AL01B. None of the parts people were certain it was the rubber strip between the cowl and the windshield. To me, based on the diagram, it looks like the strip between the bottom of the cowl and the engine bay.

Have any of you run into the same issue? Can I buy an aftermarket seal? Any advice is appreciated!
 
1 - 1 of 1 Posts
Top