Joined
·
8 Posts
There is a manual process that is as follows. I don't know if it is any different from using a scan tool.Question though, you said you reset the TCM... Did you just clear codes? I didn't think the 906BT would do a relearn on the transmission. I have a 608 here and it won't, but was told the 906 wouldn't either. I hope their wrong because I've actually been in the market for a 906TS. ....by the way, nice work!!
- Disconnect battery
- Put foot on brake for 10 seconds (drain electrical system)
- Reconnect battery
- Turn ignition to "ON" position
- Turn ignition "OFF"
- Turn ignition to "ON" position
- Turn ignition "OFF"
- Wait 15 seconds
- Start car
- Idle for 60 seconds
- Drive for 30 minutes on light/moderate throttle