Subaru Outback Forums banner
1 - 2 of 2 Posts

·
Registered
2003 Outback Limited 2.5L H4 5MT Regatta Red Pearl w/ lift and audio system
Joined
·
1,255 Posts
Discussion Starter · #1 ·
Hello gentlemen (and/or ladies ),

Right now I'm looking for a piece to use for testing. What I need is a 3/4" diameter rod of metal with a groove cut in the circumference of it in one end for a snap ring to sit in. It does not matter what kind of metal and the length doesn't need to be more than an inch.

This is exactly what I am looking for and would suit for testing purposes perfectly. The reason I would like to buy from a smaller-scale business/person is because if the test piece works for what I need it for, then I would like to commission some similar pieces made, preferably from aluminum. I'm hesitant to ask at a local machine shop because I feel like the job is too small.

Thank you for your time.
 

·
Registered
2003 Outback Limited 2.5L H4 5MT Regatta Red Pearl w/ lift and audio system
Joined
·
1,255 Posts
Discussion Starter · #3 ·
Cool idea! I will look into that; my university doesn't have any engineering degrees but the one up the road that my brother attends might. Appreciate the thoughts.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top