Subaru Outback Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I swapped my eh25D for a JDM motor I swapped the intake and wire harness from original car but now its acting like my timing is off and won’t start but my timing is dead nuts on. Any ideas what’s happening?
 

·
Registered
2005 OBXT Limited, VF37, STI intake, 5MT
Joined
·
1,335 Posts
Are you sure all of your vacuum and IACV lines are connected? EGR tubes connected? Did you disconnect the fuel lines from the intake during removal?

You may also want to verify the coil pack and wires are still in good shape, especially at the boot-wire interface.
 
1 - 2 of 2 Posts
Top