Subaru Outback Forums banner
  • Hey everyone! Enter your ride HERE to be a part of October's Outback of the Month Challenge!
1 - 6 of 6 Posts

·
Registered
2011 Impreza OBS
Joined
·
261 Posts
Discussion Starter · #1 ·
2011 Impreza OBS

Saw a picture in a different forum where someone replaced the bezels around the selector knobs for the HVAC controls, and it looked like the knobs were attached to a whole electronic module/board that plugs in.

My question is, if I find one that has the Auto HVAC controls, will it plug and play, or do I need something else to make the Auto features work?
 

·
Registered
Fresh Out of Outbacks!
Joined
·
14,499 Posts
If its anything like the legacy auto/manual systems, you would need a lot more.

Temp sensors, air box, blend door motor, possibly a different blower fan, partial wiring harness...
 

·
Registered
2011 Impreza OBS
Joined
·
261 Posts
Discussion Starter · #3 ·
Ah dang. I don't feel like disassembling my new car to install the auto. Thanks.
 

·
Registered
2006 WX8, 59E
Joined
·
1,269 Posts
There is a thread on NASIOC about doing this conversion on a previous-generation Impreza.
 

·
Registered
2011 Impreza OBS
Joined
·
261 Posts
Discussion Starter · #5 ·
I went over to NASIOC but didn't find it. Guess my search-fu is bad.
 
1 - 6 of 6 Posts
Top