Subaru Outback Forums banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Ride of the Month Challenge!

1 - 2 of 2 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
A rodent chewed up my harness and the crank postition connector is not salvageable. I tried a couple tricks to get it to work but no go.

I need a connector and at least a short pigtail, if anyone knows of a salvage car/yard or wreck I might be able to obtain one.

Here are a couple pics of the connector.

my email is erikatflybynorthdotcom
 

Attachments

·
Registered
Joined
·
7 Posts
Discussion Starter #2
Update, I was able to rewire the actual connector. But I am still getting a No crank sensor input code. I had it working but running rough for a little while, till the wire broke. I then soldered right into the pins after removing them so I know I have a good connection. No start still.

I am thinking of replacing the entire engine harness now. Anyone have a better idea or recommended source for the harness?
 
1 - 2 of 2 Posts
Top