Number one reason to get a borla knock-off
1 - 3 of 3 Posts
Joined
·
18 Posts
Would just replacing (having a shop cut out and fab up new) the Y where the left and right bank come together help much? What would removing 2nd cat do? No emissions here to worry about. Looking at my new to me h6, that y junction looks nasty.
Something like this welded in there...Amazon.com: Magnaflow 10758 Stainless Steel 2.5" Exhaust Y-Pipe: Automotive
Something like this welded in there...Amazon.com: Magnaflow 10758 Stainless Steel 2.5" Exhaust Y-Pipe: Automotive
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
Rusty Driveshaft Spline
Gen 2: 2000-2004At 300,000 miles my drive shaft has gone bad. I purchased a used drive shaft as a replacement from a junkyard, but the spline where it goes into the transmission is rusty. Am I in danger of ruining anything expensive If I go ahead and install it? If there are related threads to this question...- 3
- 121
-
MaineSpring · updated
-
3 horn configuration
Gen 2: 2000-2004Hey all, so the horn on my '01 LLBean 3.0L recently went down to only one tone. Turns out it was just a loose wire in the high note horn at the grill, and after some cleanup and reattachment, it works again. However, while doing all this I noticed that the third horn located further back...- 2
- 90
-
Post Pics of Your 2nd Gen Outback
Gen 2: 2000-2004Im new here but Just recently purchased a 2002 2nd gen Subaru Outback AWD w/ 2.5. I was wondering if we could make this a sticky and let all member post all their pictures of their rides with a brief description of mods. I did search but didn't see any threads like this. What do y'all think...- 1K
- 243K
-
H6 swap on Impreza Outback
Gen 2: 2000-2004I'm moving this over from Brucey's H6 to Baja thread at the request of the admins. More to follow...- 78
- 2K
-
David Zablotny · updated
-
Dropping the power train on an Outback
Gen 2: 2000-2004Hopefully within the next couple weeks I will be arriving at the pick and pull to find my new-to-me H6 motor and trans still in a donor car in the yard. It's set up double-high on old tire rims so I figure dropping it from the bottom would be the quickest way to get it out of the chassis. I...- 15
- 388
-
David Zablotny · updated
Join now to ask and comment!