Subaru Outback Forums banner
1 - 1 of 1 Posts

·
Registered
2014 OBW 3.6R Limited, 1997 OBW 2.5L Auto (sold, but not forgotten), and 1991 Ford F150
Joined
·
1,523 Posts
When mine failed, it was cracked clear through the side ... not from over-tightening, but just old age and vibration, I guess. So, I could see one cracking from over-tightening, too, since the shell is some kind of plastic material.

There are a couple of good threads here on replacing the sensor ... just do a search on P0325. Before removing the old one, note the angle/position of the old one so you put the new one in at the same angle/position.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top