Subaru Outback Forums banner
1 - 1 of 1 Posts

·
Registered
2005 OBXT Limited, VF37, STI intake, 5MT
Joined
·
1,610 Posts
My money is still on the TC not being seated correctly. Ask them if they had to use the bellhousing bolts to pull the engine and trans together. If there's a gap larger than 1/8 in., then something's wrong.

When rebuilding the engine, did they use an oil pan gasket? The answer should be no, but Fel-Pro likes to sell one. Did they replace or reseal the separator plate? If plastic, it should be replaced.

There's also the other inspection plate O-ring and rear main that can leak if not properly installed. Usually mitigated by reading the directions. But hey, that's what shop class is for, right?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top