Subaru Outback Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
While putting a suitcase into the rear compartment of my 2011 Outback, a wheel on the case punctured a hole in the interior black plastic trim, right beside the floor receiving latch. It was only minus 10 degrees Celsius at the time and no undue force was applied. In checking the damage, I noticed that the the plastic molding is rigid and supported all along the back, except immediately to the right and left of the latch.
Anyone experienced this problem?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top