Subaru Outback Forums banner
1 - 1 of 1 Posts

· Registered
6 Posts
Discussion Starter · #1 ·
I'm installing a Curt Class III on my 2016 Outback. I can't figure out how to achieve the 110 ft-lbs required for the four nuts. There's really not enough room to get a torque wrench on the bolts and put this amount of force on it. Can I get there with an air wrench? Any suggestions? Thanks!
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.