Subaru Outback Forums banner

Trailer brake controller wiring?

17629 16
Alright, so I got this T-connector:
Tow Ready - T-Connector Outback, Forester - 118467 — hitchweb

Along with a Universal brake control installation kit:
Reese, Pre-Wired Brake Mate Kit Adapter, 7-Way Flat Pin Connector with Brake Control Wiring Installation Kit — hitchweb

There's a nice wiring diagram here:
http://www.hitchweb.com/file_manager/view/images/92/docs/tr118607.pdf

And I got the Tekonsha P3:
Tekonsha - Brake Control: "P3" - Inertia Activated; CAP: 2 to 8 Brake Systems - 90195 — hitchweb

I might put the wires through the cabin, as I've seen here:
http://www.subaruoutback.org/forums/104-gen-4-2010-present/46269-7-pin-trailer-wiring.html

3 Questions:

(1) Any recommendations/pics of a brake controller mounted in a 2010+ Subaru? I'm wondering about removing the panel below the steering wheel and cutting out a small rectangle to poke the controller face through.

(2) Where do I tap into the brake wiring?

(3) I also got a solenoid to mount under the hood (so I don't drain the battery). Where can I tap into a switched power source?
1 - 2 of 2 Posts
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top