Subaru Outback Forums banner

Tried to fix my knock sensor

4148 Views 13 Replies 6 Participants Last post by  andrewthehiggins
Alright everyone, I got the P0325 code and I did some research about it. I decided it was a cracked knock sensor like everyone says happens to them... Well I pulled it off and looked it over really well and it wasn't cracked but I already bought a new one so I decided to put the new one on. I put it on and started up my car and it starts up fine but then dies after a second, then if I give it gas it will die even quicker. Now when I scan for codes it doesn't show any codes. I put the old sensor back on and now the same thing. I'm not incompetent in working on cars but I'm also no expert. Any help?
1 - 1 of 14 Posts
As rule, whenever I changed a sensor, i pull the battery cables off, turn on ignition for 30 secs then hook back up to reset computer. This my first subie and have never worked on one, but with other cars I have had, an ECM reset was beneficial when swapping sensor components. Actually not even sure if that resets a Subie?
1 - 1 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.